The principal behind our salt-less anti-scale media is quite simple. The salt-less anti-scale media acts as a catalyst by accelerating the transformation of the calcium and magnesium minerals into harmless “Nano” particles. When the inlet water goes into the water conditioner tank, the salt free scale control media which then acts as a catalyst and pulls the hardness minerals of calcium and magnesium and then transforms these calcium and magnesium minerals into inactive Nano crystal particles. These Nano-scopic particles make their way through plumbing systems without attaching on to pipes, fixtures, valves, or heating elements. An important secondary benefit is that the existing scale in pipes and equipment is also dissolved over time. The manganese and calcium already built up on the walls of pipes and equipment will slowly dissolve and in just a few short months mineral build up will be eliminated. Contact time with water 5 seconds, pH range 6-9, chlorine less than 3 ppm, iron (Fe), hydrogen sulphide (H2S), oil and grease must be removed prior CATALYTIC MEDIA conditioner. Max. temperature up to 150° F however the maximum temperature is governed by media tank and other components used in a system. Hardness level difference If the water is tested after the CATALYTIC MEDIA System is installed the hardness level will remain the same as a test for “total hardness” in actuality is a test for the presence of calcium and magnesium minerals which are retained in the water. The test can sometimes even test slightly higher due to the existing scale being removed from the plumbing.
